Features of silent pulley

Features of silent pulley
The mute chute is a device used to fix the guide plate and track. It is composed of two or three sliding parts: one is installed on the bracket; The other is installed on an adjustable support shaft (drum). When moving the guide plate, the position and direction of the guide plate can be controlled by adjusting the bolt on the support shaft to change its position.
What are the characteristics of the silent pulley
1. Simple and reliable structure
Due to the use of new bearing materials and special processing technology, the product life is greatly extended and has high reliability.
2. Long service life
The bearing is maintained with imported wear-resistant lubricant to ensure the long-term operation of the product.
3. Low noise
Special oil seal design is used to effectively reduce noise.
4. High accuracy
It is manufactured by precision machining center to ensure the high quality of products.
5. No pollution
The use of environment-friendly lubricating oil avoids the secondary environmental pollution caused by traditional oil.
6. Wide applicability
It is applicable to all kinds of products with different specifications and models.
7. Security
All parts are subject to strict inspection standards and manufactured in accordance with relevant safety requirements.
Range of application of silent pulley
It is widely used in various small workpiece assembly operations in electronic and electrical equipment, mechanical parts and other industries.
Precautions for silent pulley
1. Please read the regulations and requirements in this manual carefully before operation.
2. Do not put your hands into the slider.
3. Overloading is strictly prohibited.
4. It is forbidden to knock with a hammer.
5. Please avoid collision with other objects when using.
Installation method of silent pulley
(1) Select the appropriate aperture as required.
(2) Fix the base on the table and fasten it with screws. (Note that the thickness of the base should be slightly greater than the width of the slider).
(3) Install the top cover, cover the dust cover, and then unscrew the lock catch to complete the assembly.
(4) Turn on the power switch and press the button to start the motor to run to normal speed
Common fault analysis of silent pulley
Some abnormal phenomena will occur during the use of the silent carriage, such as: unable to rotate or slow rotation speed, etc. These are normal phenomena. The reasons for the above are mainly as follows:
1. The sliding rod surface is seriously worn;
2. Fatigue deformation of spring;
3. The limiter fails;
4. The gearbox is damaged.
The above is the introduction of the features of the silent slide rail. When using it, we must use it in the correct way, and pay attention to the maintenance and maintenance at ordinary times. When it can not rotate or the rotation speed is slow, it can be repaired according to the above method. Do not put your hand in during use to avoid accidents. If you have other relevant questions, you can come to consult us.